Our enhanced Nissan interface supports code retrieval/resetting, sensors, and actuations from the engine, BCM, transmission, ABS, airbags, 4WD systems, and CAN systems. Coverage includes the Work Support configuration commands such as Target Idle Ignition Adjustment; with it you can permanently advance your ignition timing to gain few extra HP. Trouble code retrieval includes the NATS 5.0 system and the detailed status byte support. Also supported is the diesel models (Juke, Micra, Navara, NV, Pathfinder, QashQai, XTerra).
Finally, we seamless integrate CAN and non-CAN systems so that you won't have to worry about switching hardware to retrieve all the troubles codes from each module.
System Tests:
- Self-Diagnostic (Airbag)
- ECU Part Number (Airbag)
- Diagnostics Record (Airbag)
- Reset ECU (Powertrain)
Work Support/Configuration Functions (Some 01+ and Most '03+)
- Target Idle Ignition Adjustment
- Target Idle RPM Adjustment
- Idle Air Volume Learn
- Self-Learning Control
- Stroke Sensor Zero Point Learning Reset
- Brake Test Count
- ODS Zero Point Reset
- Actuator Zero Point Learning
- Clear Battery Gradual Capacity Loss / Clear Battery Charge Discharge Information
- Position Learning Value Clear / Shift AN Test Count
- Display and Conformation CVTF Deterioration Date
- G Sensor Calibration AT / ECU Part Number AT
- Erase Calibration Data / Erase Learning Value / Erase Memory Data
- GTR Specific Clutch Gear Learning / Show Oil History / High Oil Temp Warning History / Adjust Clutch A and B Capacity / Clutch A and B Touch Point
- Standard Height Level / Adjust Height INI / Clear Height INI
- Auto Activation / Brake Operation / Brake Release / Clutch Sensor Reset / Finish Brake Pad Replacement / G Sensor Calibration / Start Brake Pad Replacement
- Reset Auto Back Door Status
- Erase Last Driver Information, Erase Key Allotment User, Erase Personal Settings
- Initialize Camera Image Calibration, Steering Angle Sensor Adjustment, Calibrate Camera Image Front, Camera Calibrate Camera Image (Driver / Passenger / Rear)
- Auto Aim, Aim Check
CAN Module Configurations:
- Door Lock Unlock Set
- Anti-Lock Out Set
- Set IL Door Unlock
- Room Lamp Off Time Set
- Room Lamp On Time Set
- Keyless Entry Horn Chirp Set
- Keyless Entry Hazard Lamp Set
- Keyless Entry Multi-Answer Back Set
- Keyless Entry Auto Lock Set
- Keyless Entry Panic Alarm Set
- Keyless Entry Trunk Open Set
- Keyless Entry Power Window Down Set
- Head Lamp Battery Saver Set
- Head Lamp Custom Light Setting
- Head Lamp Illumination Delay Set
- Wiper Speed Setting
- Security Alarm Set
- Theft Alarm Trigger Erase
14pin DDL1 ('96 - '00) support will require a new pigtail. 14pin DDL1 is also used on some '00 and '01 ABS and TCM controllers.
16pin DDL1 for '01 - '10 (Sentra and Versa AT controllers) is available with the ProLine hardware.
Do not use on '96 - '03 Nissan Quest, damage to the connector may occur.
You may also be interested in:
|
|
|
|
A GOOGLE AD IS SHOWN BELOW-IT IS NOT ASSOCIATED WITH THE PRODUCT ABOVE
