Used Cummins Softcover Manual in Very Good Condition
This manual covers the calibration instructions for the Cummins PT (type G) fuel pump on test stands made or approved by Cummins Engine Company, Inc., and equipped with an accurate flowmeter and orifices.
A binder is available for your PT (type G) manual. It can be purchased by ordering Bulletin No. 983692. Fuel Pump test stands without flowmeter are not as accurate and use of these should be discontinued or conversions applied; however, until this is accomplished, calibration values for these test stands are available from Bulletin 983533 and apply only to fuel pumps released during and prior to 1963.
Table of Contents
Calibration Test Equipment
Calibration Instructions
Fuel Pump Trouble Shooting
Adjustment On Engine
List of Tables
Test Standards for Conversions
Governor Springs and Specifications
Idle Spring Plunger Data
Torque Springs and Specifications
MVS and SVS Governor Springs and Specifications
Calibration Recheck Specifications
Index of Instructions
Brake Horsepower Formula
Calibration Procedure
Calibration Value Precautions
Cleaning F lowrators
Check Point Pressures
Engine Hi-Idle Speed Adjustment
Engine Power Check
Filter Restriction
Flow Adjustment
Fuel Manifold Adjustment on Pump
Fuel Manifold Adjustment on Engine
Fuel Pump Adjustment on Engine
Fuel Rate Adjustment on Engine
Gear Pump Test
Governed Speed Adjustment
Governor Cut Off Speed
High Torque R ise Fuel Pumps
High Idle Adjustment on Engine
Horsepower Conversions
Housing Porosity Check
Instruments
Idle Speed Adjustment on Pump
Idle Speed Adjustment on Engine
MVS Governor Leakage
MVSIdle Speed
Nameplate Stamping
Pump Hookup on Engine
Pump Hookup on Test Stand
Pump Run In
Pump Seal Check
Recheck Specifications
Sealing Fuel Pump
SVS Idle Speed
Test Oil
Test Stands
Throttle Leakage Adjustment on Pump
Throttle Leakage Adjustment on Engine
Trouble Shooting with Test Stand
Vacuum Adjustment
Weight Assist Pressure Check
A GOOGLE AD IS SHOWN BELOW-IT IS NOT ASSOCIATED WITH THE PRODUCT ABOVE
